Open-Source Security Intelligence

Know every vulnerability
before it knows you.

DevGuard continuously monitors your dependencies and alerts you when CVEs like this one affect your stack — with real-time threat intelligence built for developers.

Search

CVE-2026-93669

MediumCVSS 4.7 / 10
Published Nov 16, 2026·Last modified Nov 17, 2026
Affected Components(34)
zephyrproject-rtos/zephyr
4.2.0-rc1
zephyrproject-rtos/zephyr
4.3.0-rc2
zephyrproject-rtos/zephyr
3.7.0-rc1
1 / 12
Description

The ITE IT8xxx2 SHI host-command backend in subsys/mgmt/ec_host_cmd/backends/ec_host_cmd_backend_shi_ite.c arms the SPI peripheral before its receive context exists. shi_ite_init_registers() sets the state machine to SHI_STATE_READY_TO_RECV and calls irq_enable() while the device initializes at POST_KERNEL priority CONFIG_KERNEL_INIT_PRIORITY_DEFAULT (40), but data->rx_ctx and data->tx are only assigned later by shi_ite_backend_init(), which ec_host_cmd_init() invokes at CONFIG_EC_HOST_CMD_INIT_PRIORITY (default 80).

If the attached host processor starts a SPI transaction inside that window, the Rx-valid-length interrupt fires, shi_ite_int_handler() passes its state check and calls shi_ite_parse_header(), which stores the host-derived request length through the still-NULL data->rx_ctx. On the IT8xxx2 low addresses are not backed by RAM, and with CONFIG_NULL_POINTER_EXCEPTION_DETECTION_PMP the first bytes of the address space are explicitly made inaccessible, so the store raises a fatal access fault in interrupt context. The window widens further when CONFIG_EC_HOST_CMD_INITIALIZE_AT_BOOT is disabled and the application calls ec_host_cmd_init() itself.

The result is a kernel panic on the embedded controller: with Zephyr's default fatal handler the CPU halts, so the controller stops servicing host commands until a hardware reset. Because the trigger is traffic from the attached host processor -- an untrusted peer from the controller firmware's point of view -- software on that host can provoke the fault by forcing a controller reset and issuing transactions during the reboot, turning a recoverable reset into a persistent outage. Impact is limited to availability: the faulting address is fixed and not attacker-chosen, so no memory-corruption primitive follows.

The fix leaves the interface at SHI_STATE_DISABLED with the interrupt masked during device init, moves irq_enable() into shi_ite_backend_init() after the buffers are published, and makes shi_ite_int_handler() reject a NULL data->rx_ctx while write-clearing IT83XX_SPI_ISR and IT83XX_SPI_RX_VLISR so that an unexpected early interrupt cannot storm.

Upload your SBOM

Upload your own SBOM in CycloneDX 1.6 or higher (JSON) directly here to check your vulnerabilities.

Risk Scores
Base Score
4.7

The vulnerability requires local access to the device to be exploited. It is difficult for an attacker to exploit this vulnerability and may require special conditions. An attacker needs basic access or low-level privileges. No user interaction is needed for the attacker to exploit this vulnerability. The impact is confined to the system where the vulnerability exists. There is a high impact on the availability of the system.

Threat Intelligence
4.3

Exploitation attempts have been detected. Elevated vigilance and prompt remediation are advised.

EPSS
0.09%

The exploit probability is very low. The vulnerability is unlikely to be exploited in the next 30 days.

Exploit
Not available

We did not find any exploit available. Neither in GitHub repositories nor in the Exploit-Database.

Scan your project

Continuously monitor your dependencies and get alerted when vulnerabilities like this one affect your stack.

Checkout DevGuard